Thermaltake recommends the following steps to be taken
Pacific series radiators and water blocks
- To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
- Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while protecting the entire liquid loop from corrosion.
- Before storing your water cooling components, please clean, rinse and dry. This will ensure a longer lifespan for your components.
Thermaltake recommends the following steps to be taken after completing your water loop
- It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
- Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
- DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
- Fill the reservoir to the top as it will prevent air from going into the pump
- If necessary tilt the system slightly from side to side to bleed the air out of the loop.
- Place some paper towels under fittings and joining points to test for leaks.
- Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
- Before starting, flush out your system correctly to prevent any coolant or unwanted particles sticking to your tubes, radiators and other cooling components.
- Coolant might fade over time.
|Dimensions||528(L) x 123 (W) x 128 (H)|
|Tube Dimensions||OD : 16mm , ID : 12mm , L : 500mm|
- Pacific G1/4 PETG Tube 16mm OD Compression – Chrome x10
- Pacific G1/4 90 Degree Adapter – Chrome x2
- Pacific G1/4 PETG Tube 90-Degree compression - 16mm OD – Chrome x2
- Pacific G1/4 Female to Male 10mm extender – Chrome x2
- V-Tubler PETG Tube 16mm(5/8”) OD 500mm 4Pack x1
- C1000 Opaque Coolant White x1
- Silicone cord x 1